HEWLETT PACKARD (HP) LJ COMPANION
Service Manual

Paper Sensor Lever Removal
(Figure 6-3, Reference 1) Follow steps 1 to 11 and steps 15 and 16 under �Disassembly,� then complete the following steps:
35 Grasp one of the four paper guides with the needlenose pliers and pull.

Repeat until all paper guides are removed. 36 Remove the spring. The paper sensor lever is held in place by one snap-in hinge on the left side of the back of the chassis.
37 Using the small flat-blade screwdriver, pry the paper sensor lever from

the hinge. 38 Slide the paper sensor lever to the left to remove.

Motor Removal
(Figure 6-3, Reference 9) Follow steps 1 to 11 and steps 15 to 24 under �Disassembly,� then complete the following steps:
39 Cup the motor with one hand (to prevent it from falling once the screws

are removed). 40 Remove the two screws on the motor with the Phillips-head screwdriver. 41 Remove the spring. The motor is now detached from the chassis.

Image Sensor Removal
(Figure 6-1, Reference 8) Follow steps 1-11 under �Disassembly,� then complete the following steps:
42 Grasp the image sensor on one side and pull it toward the opposite side

5
Maintenance

while at the same time using your thumb to press outward on the front cover tab. 43 Disconnect the connector wire to the image sensor.

EN

Removal and Replacement

5-5